What is the problem if the ultrasonic probe tip is used improperly?

1. The ultrasonic probe tip is not put into the sample and will cause damage to the instrument.

 2. The ultrasonic homogenizer sample is splashed or foamed too much. The small power knob should be slightly adjusted or the Tip should be shortened.

 3. Ultrasonic homogenizer tip or transducer damage will cause no waves during ultrasound.

  4, the ultrasonic homogenizer tip is not tightened, there is no special tool or insufficient force, the use of vibration, causing no waves or waves is small.

  5, ultrasonic probe tip wear, frequency shift occurs, no wave or wave is very weak, should adjust the tip selection switch on the rear panel according to the instruction manual (can change the corresponding position).

  6. When the ultrasonic probe tip hits the container wall during operation, the protection light will appear and it will not work.