Autoclave operation steps

1. First remove the inner layer sterilization barrel, and then add an appropriate amount of water to the outer layer pot to make the water surface and the triangle shelf level.

2. Put back the sterilization bucket and load the items to be sterilized. Be careful not to pack too much, so as not to hinder the flow of steam and affect the sterilization effect.

3. Cap and insert the exhaust hose on the cover into the exhaust groove of the inner sterilization tank. Then tighten the two bolts at the same time in a symmetrical manner to make the bolts tight and do not leak.

4. Turn on the power supply and open the exhaust valve at the same time to boil the water to remove the cold air from the pot. After the cold air is completely drained, close the exhaust valve so that the temperature inside the pot gradually increases as the steam pressure increases. When the pressure in the pot rises to the desired pressure, the heat source is controlled to maintain the pressure for the required time.

5. After the time required for sterilization, turn off the power or turn off the gas, let the temperature inside the sterilization pot drop naturally. When the pressure of the pressure gauge drops to 0, open the exhaust valve, loosen the bolt, open the cover, and remove it. Bacterial items.