Application of high pressure homogenizer in carbon nanotubes

Nov 07, 2018

Leave a message


Brief introduction to the principle of homogenizer


   Under the action of the reciprocating motion of the plunger, the material is transported into an adjustable-sized valve block, which is subjected to extremely strong compression. When passing through the restriction slit, it hits the homogenizing valve impact ring at a very fast speed. The cavitation effect, the impact effect and the shearing effect are generated to uniformly disperse the agglomerated material to form a stable and uniform dispersion.

image

Homogenizing valve working principle diagram

Carbon nanotubes

image


Carbon nanotubes are a new type of carbon material. The carbon nanotubes arranged in a hexagonal shape form several to ten layers of coaxial tubes. The layer is kept at a fixed distance between the layers, about 0.34 nm, and the diameter is generally It is 2-20 nm.

Carbon nanotubes have been widely used in plastic modification, micro circuit chips, electrostatic shielding, lithium battery electrodes, etc. for their excellent performance.


Dispersant selection:


Surfactants of CNTs often appear in the literature are NaDDBS, SDS, Triton X-100. Experiments show that compounds with aromatic groups have better binding ability to CNTs, stronger adsorption capacity, and better dispersion. effect.


The choice of dispersant dosage:


For multi-walled carbon nanotubes with large outer diameter, the recommended dosage is 10-15% for carbon nanotubes, and the amount of carbon nanotubes with smaller outer diameter is 60-70%. For single-wall tubes, the recommended dosage is 100-300. %.


This ratio is for reference only. The specific dosage has a great relationship with the quality of the raw materials. In the experimental stage, the dispersion of carbon nanotubes is generally prepared by ultrasonic equipment. When the sample volume rises, the operation time of the ultrasonic waves is too long. Conducive to the pilot and production. Grinding equipment can not properly control the temperature of the sample, the production conditions can not be controlled, and it is easy to cause batch differences in product quality.


The high-pressure dispersing device is a continuous flow device, which can be cooled in the feeding and discharging, can control the temperature well, and achieve the consistency of the production conditions. It is the best choice for the carbon nanotube dispersion pilot and production equipment.


Experiment procedure:


1. Use two-stage homogenization module, carbon material special dispersion valve, external coil heat exchanger, chiller temperature set to 10 °C


2. After mixing the sample, stir it with a stir bar. After the equipment is cleaned with solvent, start the homogenization operation, adjust the dispersion pressure to 500 bar, wait for 5-10 seconds, then connect the homogenized sample to the beaker. Start a cycle of low pressure


3. High pressure 1200bar high pressure dispersion twice, pay attention to temperature control


Experimental phenomena:


1. The initially stirred sample, the carbon nanotubes are suspended in a solvent


2. After pretreatment, the carbon nanotubes are initially dispersed in a solvent, and the viscosity of the sample is increased.


3. After the high pressure treatment, the viscosity of the sample is reduced. After the high pressure treatment of the aqueous solution is repeated twice, the sample flows down the wall of the beaker, no visible particles, good fluidity, no wall attachment, no precipitation.


According to the test results, the carbon nanotubes are initially entangled, and the single roots are dispersed in the solution, the dispersibility is greatly improved, and the solution can be stably placed for a long time without delamination.

image

Electron micrograph of compound conductive agent is summarized: high-pressure homogenization dispersion is very suitable for the preparation of carbon nanotube (single-wall/multi-wall) dispersion. It has good adaptability to the viscosity of slurry, homogenizer, and high dispersion efficiency. The process is controllable and easy to use with other reaction equipment, which is a good choice for the preparation of new materials.

initpintu_副本

Send Inquiry