General faults and solutions for high pressure homogenizers
Jun 13, 2019
Leave a message
High pressure homogenizers usually have the following failures:
| Faults | General cause | Solutions |
| Insufficient flow rate is not high | Valve leakage Seal damage, homogenization valve leakage | Inspection, repair, replacement |
| Pressure gauge pointer is too big | Valve door leakage, seal damage Bad pressure gauge assembly | Inspection, repair, replacement |
The valve works unevenly Large pressure fluctuations | Partial valve leakage | Inspection, repair, replacement |
| Leakage fluid at the plunger | Plunger seal wear | replacement |
| Impact sound in the pump body | The plunger is worn, there is gas in the pump, and there is debris in the pump. | Use the bleed screw to remove, open the chassis check, and eliminate |