Contact Us
TEL: +86-574-88350013
Mob: +8613003752008
E-mail: info@scientz.com
Address: No.65, Mujin Road, National Hi-Tech Park, Ningbo, Zhejiang, China
Home > News > Content
Test Code For Water Bath
Jul 03, 2017

1, the water tank should be placed on a fixed platform, the power supply voltage must be in line with the requirements of the product voltage, power sockets should use three-hole safety check sockets. Grounding wire must be installed.

2. Add clean water to the total height of $number in the sink.

3, the power switch to the Open thermostat panel that has a digital display power.

4. Press the temperature button of the temperature controller, the temperature of the digital display is the actual temperature. At the same time rotating temperature adjustment knob, observe the display value, select the desired operating temperature.

5, press the setting button again, at this time the temperature of the digital display is the temperature measured in the sink. Hot indicator light, instrument into the automatic thermostat control state.