Contact Us
TEL: +86-574-88350013
Mob: +8613003752008
E-mail: info@scientz.com
Address: No.65, Mujin Road, National Hi-Tech Park, Ningbo, Zhejiang, China
Home > Knowledge > Content
How to distribute the ultrasonic cleaner transducer
Aug 08, 2018

At present, some ultrasonic cleaning machines, the transducers stuck to the bottom or wall of the cleaning tank are too densely distributed, one next to the other. The input transducer has a power intensity of 2-3 watts per square centimeter. This high strength accelerates the cavitation corrosion of the surface of the stainless steel plate (the surface in contact with the cleaning fluid) and shortens the service life. Too high. A large number of large bubbles are generated near the surface of the steel sheet, which increases sound transmission loss and weakens the cleaning action away from the transducer. Generally, the power intensity is less than 1.5 watts per square centimeter (calculated according to the area of the steel plate to which the transducer is attached). If the cleaning tank is deep, in addition to the transducer attached to the bottom of the tank, the bonded transducer should also be considered on the wall of the tank, or only on both sides of the tank.

     The bonding quality of the transducer and the cleaning tank has a great influence on the quality of the ultrasonic cleaning machine. Not only should it be adhered, but also the glue layer should be uniform, no glue and no cracks allowed, so that the ultrasonic energy can be transmitted to the cleaning liquid to the maximum to improve the efficiency and cleaning effect of the whole machine. Some cleaning equipment is currently used to prevent the transducer from falling off the cleaning tank. The fixing method of the screw and the glue is adopted, and the connection method can well prevent the transducer from falling down. However, pay attention to the quality of the screw welding. If it is not perpendicular to the surface of the stainless steel plate, the rubber layer is not uniform, even cracks or lack of glue, the energy transmission will be weakened; If the welding is not good, it will affect the smoothness of the stainless steel surface, leading to accelerated cavitation corrosion and shortening the service life, so the welding quality is very important.

    One of the methods for judging the quality of the bond is to measure the temperature rise of the transducer after the tank is filled with water and turned on for a period of time. If the temperature rise of a transducer in a large number of transducers is particularly fast, it indicates that the transducer may not bond well. Because the sound radiation is not good at this time, most of the electric energy is consumed on the transducer and generates heat. Another method is to measure the impedance of the transducer one by one under small signal conditions to determine the bond quality.


Previous: Multi-frequency ultrasonic cell disruption knowledge

Next: Ultrasonic cleaning